 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| AWT6103M5 Cellular Dual Mode AMPS/TDMA Mode 3.5V/30 dBm Linear Power Amplifier Module Advanced Product Information Rev. 1 * * * * * * * * * * FEATURES InGaP HBT Technology High Efficiency 50% AMPS High Efficiency 45% TDMA Low Leakage Current (<25A) SMT Module Package Small Foot Print (6mm x 6mm) Low Profile (1.6mm) 50 Input and Output Matching Low Quiescent Current (ICQ 50mA Typ) Shut Down and Mode Control APPLICATIONS * Dual Mode AMP/TDMA Handsets 6x6mm Module Package Description The AWT6103 is a 3.5V power amplifier module for use in Dual Mode AMPS/TDMA handsets. Absolute Minimum and Maximum Ratings S IGNAL Supply Voltage (Vcc ) Input Power (RF IN ) Bias Voltage (V REF ) V M O D Voltage (V MOD ) Storage Temperature (T STG ) Operating Temperature (T C ) -55 -25 MIN MAX +5 +10 +3.5 +3.5 100 80 UNITS V dBm V V C C AWT6103M5 Electrical Specifications AMPS: (Unless otherwise specified: Vcc = 3.5V, Z = Z IN OUT =50 System, TC = 25 C) Maximum 849 Units MHz V V mA dBm dBm 2:1 2:1 Parameter Frequency Range Supply Voltage Range Ref voltage Range Ref current Output Power, V CC = 3.5V Output Power, V CC = 3.0V Input Impedance Output Impedance Efficiency Pout = 32 dBm Icq (V MODE = 2.7V) Low Power Mode Noise at Receiver Band P OUT 32 dbm Gain, P OUT= 32 dBm Leakage Current V CC = 3.5V; V REF = 0V ; V MODE = 2.7V Harmonics 2fo, P OUT = 32 dBm 3fo, P OUT = 32 dBm Stability (out of band load VSWR < 20:1) (in band load VSWR < 10:1) Ruggedness Stress for no permanent degradation or failure, VCC = 5.0 V Minimal 824 3.0 2.75 Typical 3.5 2.8 2 5.0 2.9 32.0 31.0 50 50 -90 26 25 -30 -30 -60 % mA dBm/30 kHz dB A dBc dBc dBc, all spurious Pin - 50 dBm ... +0 dBm 10:1 Bias Table V MODE High High Low V 2.7 2.7 0 ICQ Typ 50 mA 50 mA 100 mA Power Range All Low High POUT Levels 0-32 dBm 0-22 dBm 22-30 dBm Mode AMP All Power NADC Low Power NADC High Power 2 AWT6103M5 Electrical Specifications (TDMA 824-849 MHz) (Unless otherwise specified: Vcc = 3.5V, Z = Z =50 System, TC = 25 C) IN OUT Parameter Frequency Range Supply Voltage Range Ref. Voltage Range Ref. Current Output Power, V CC = 3.5V Output Power, V CC = 3.0V Input VSWR Output VSWR Power Added Efficiency Pout = 30 dBm Power Added Efficiency Pout = 16 dBm (V MODE = 2.7V) Low Power Mode Icq (V MODE = 2.7V) Low Power Mode Linearity (P OUT avg. = 30 dBm) & V CC =3.5V ACPR +/- 30 kHz ACPR +/- 60 kHz ACPR +/- 90 kHz Noise at Receiver Band Pout 30 dbm Gain, P OUT = 30 dBm Leakage current V CC =3.5V ; V MODE =2.7V ; V REF = 0V Harmonics 2fo, P OUT = 30 dBm 3fo, P OUT = 30 dBm Stability (out of band load VSWR < 20:1) (in band load VSWR < 10:1) Ruggedness Stress for no permanent degradation or failure, V CC = 5.0 V Minimum 824 3.0 2.75 Typical Maximum 849 Units MHz V V mA dBm dBm 3.5 2.8 2 5.0 2.9 30 29 2:1 2:1 45 % 7 % 50 NADC - modulation -28 -48 -50 -90 25 28 25 -30 -30 -60 31 mA dBc dBc dBc dBm/30 kHz A dBc dBc dBc, all spurious Pin - 50 dBm ... +0 dBm 10:1 3 AWT6103M5 Pin Description P in 1 2 3 4 5 6 7 Name V CC R F IN V REF V MODE V CC R F OUT GND D e s c r ip t i o n Supply Voltage R F In p u t S i g n a l Bias M o d e C o n trol Supply Voltage RF output Ground Package Outline Top View 6.0 ANADIGICS, Inc. 35 Technology Drive Warren, New Jersey 07059 Tel: (908) 668-5000 Fax: (908) 668-5132 http://www.anadigics.com Mktg@anadigics.com IMPORTANT NOTICE ANADIGICS, Inc. reserves the right to make changes to its products or discontinue any product at any time without notice. The Advanced Product data sheets and product specifications contained in this data sheet are subject to change prior to a products formal introduction. The information in this data sheet has been carefully checked and is assumed to be reliable. However, ANADIGICS assumes no responsibility for inaccuracies. ANADIGICS strongly urges customers to verify that the information they are using is current before placing orders. WARNING ANADIGICS products are not intended for use in life support appliances, devices, or systems. Use of an ANADIGICS product in any such application without written consent is prohibited. 4 |
Price & Availability of AWT6103M5
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |